Engineering, 11.11.2019 22:31 gamboaserg

2.12. challenging content

the international temperature scale of 1990 (its-90) established fit curves for taking voltage data to temperature for various standard thermocouple types. these fit curves yield values of temperature from voltage that are within ±0.04 °c for k-type thermocouples. as a result, a device programmed with these fit curves and an extremely accurate cold-junction temperature compensation could result in thermocouple measurements for temperature that are within ±0.04 °c. use these fit curves for plotting the temperature versus voltage for a k-type thermocouple over a temperature range of 0 to 1000 °c.
determine a linear fit curve (slope and intercept) for determining temperatures from voltage over this temperature range.

compare the values from the linear fit to the fit curves by obtaining a scatter plot in excel. plot the difference between the temperatures obtained from your linear fit and the its-90 curve fit on the y-axis. on the x-axis plot the temperature from 0 to 1200 °c. your results should be submitted separately in an excel file.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?

Answers: 3

Answer

You know the right answer?

2.12. challenging content

the international temperature scale of 1990 (its-90) establish...

Questions