subject
Engineering, 20.12.2019 06:31 skylar1315

(a) what is the period of the forced oscillation? what is the numerical value (modulo 2π) of the angle α defined by (4)?

(b) in this question you are asked to modify the file lab06ex1.m in order to plot the complementary solution of (1), that is, the first term in (2). first define in the file the angle α (alpha) using (4), then evaluate the complementary solution yc by subtracting the quantity c cos(ωt − α) from the numerical solution y. plot the resulting quantity. does it look like an exponentially decreasing oscillation? why or why not? include the modified m-file and the corresponding plot.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
question
Engineering, 04.07.2019 18:20
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
question
Engineering, 04.07.2019 19:20
Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?
Answers: 2
question
Engineering, 05.07.2019 23:20
Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket
Answers: 3
You know the right answer?
(a) what is the period of the forced oscillation? what is the numerical value (modulo 2π) of the an...
Questions
question
Mathematics, 03.05.2021 18:50
question
Mathematics, 03.05.2021 18:50
question
Mathematics, 03.05.2021 18:50
question
Mathematics, 03.05.2021 18:50
Questions on the website: 13722367