Engineering, 25.01.2020 04:31 mem8163

Assume a strain gage is bonded to the cylinder wall surface in the direction of the hoop strain. the strain gage has nominal resistance r0 and a gage factor gf. it is connected in a wheatstone bridge configuration where all resistors have the same nominal resistance; the bridge has an input voltage, vin. (the strain gage is bonded and the wheatstone bridge balanced with the vessel already pressurized.)calculate the voltage change ∆v across the wheatstone bridge when the cylinder is pressurized to ∆p = 2.5 atm. assume the vessel is made of 3004 aluminum with height h = 21 cm, diameter d = 9 cm, and thickness t = 65 µm. the gage factor is gf = 2 and the wheatstone bridge has vin = 6 v. the strain gage has nominal resistance r0 = 120 ω.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

You know the right answer?

Assume a strain gage is bonded to the cylinder wall surface in the direction of the hoop strain. the...

Questions