Engineering, 17.04.2020 21:14 katelynzaro

Two cylinders are to be press-fitted together so that the principal stresses with the greatest absolute value is not to exceed 60 percent of the yield strength of the material. Both members are made of steel with a yield strength of 80,0001b/inZ^2, E = 30 times 106 lb/in^2, and v = 0.29. The nominal diameters of the cylinders are 1.0, 1.5, and 2.0 inches.

a. Determine the maximum acceptable radial interference and the corresponding interface pressure.
b. Under the conditions of part (a) plot the stress distribution for each member
c. If under the conditions of part (a) the assembly is further subjected to an internal pressure of 5000 lb/in^2, determine the resulting stress distribution in both members using the method of superposition.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 19:10

The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj

Answers: 2

Answer

You know the right answer?

Two cylinders are to be press-fitted together so that the principal stresses with the greatest absol...

Questions