A bushing
Engineering, 22.04.2020 22:14 gabby640
4. The outer end of a control arm is attached to the steering knuckle through a
A bushing
B. spring
ec ball joint
D. tie rod end
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
Engineering, 04.07.2019 18:20
Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k
Answers: 2
You know the right answer?
4. The outer end of a control arm is attached to the steering knuckle through a
A bushing
A bushing
Questions
Spanish, 19.05.2020 03:05
Mathematics, 19.05.2020 03:05
Mathematics, 19.05.2020 03:05
Mathematics, 19.05.2020 03:05
Mathematics, 19.05.2020 03:05
Mathematics, 19.05.2020 03:05
English, 19.05.2020 03:05
English, 19.05.2020 03:05
Mathematics, 19.05.2020 03:05
Health, 19.05.2020 03:05
