Engineering, 05.05.2020 01:26 Dbranden1038
4. Look at the engine block shown in the figure. The engine shown in this figure is a/an
A. four-cylinder, horizontally opposed engine.
B. eight-cylinder, V-type engine.
C. four-cylinder, in-line engine.
D. six-cylinder, V-type engine.
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?
Answers: 1
You know the right answer?
4. Look at the engine block shown in the figure. The engine shown in this figure is a/an
Questions
Mathematics, 01.03.2021 22:10
History, 01.03.2021 22:10
Social Studies, 01.03.2021 22:10
Computers and Technology, 01.03.2021 22:10
Mathematics, 01.03.2021 22:10
Mathematics, 01.03.2021 22:10
Mathematics, 01.03.2021 22:10
Mathematics, 01.03.2021 22:10
Mathematics, 01.03.2021 22:10
