Engineering, 05.05.2020 21:29 casie65
The aluminum strut AB has a hollow, rectangular cross-section with a thickness of 2 mm. The strut is rigidly attached to the wall at A and is supported by a pin and bracket at B. The end at B can rotate freely about the z-axis, but the bracket prevents rotation about the y-axis. Material properties for aluminum are E = 70 GPa and SY = 250 MPa, and a factor of safety of 2.5 is specified. Calculate the maximum allowable centric load P for the strut.
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 04.07.2019 18:20
Wiy doeres rere okhn a pump whon working betwon the same pressure range?
Answers: 2
Engineering, 04.07.2019 19:20
In the winter, in order to keep the classroom steadily at 68 f before 10 pm, heating with an average rate of 42,000 btu/hr is provided. assume the outdoor temperature maintains at 32°f, determine the electrical power (kw) required to (a) operate a reversible heat pump (b) operate a real heat pump with a cop (7) of 4.5 and (c) operate an electrical-resistance heater.
Answers: 3
You know the right answer?
The aluminum strut AB has a hollow, rectangular cross-section with a thickness of 2 mm. The strut is...
Questions
Computers and Technology, 02.12.2019 22:31
