Engineering, 20.05.2020 02:57 dodsonh16

For a Digital Muti-meter when set to the Diode Test, It will indicate continuity when the RED lead is connected to the Anode of a known good Diode and the black lead is connected to the Cathode (will show Forward voltage drop). When the leads are Reversed, there is no continuity indicated. With this knowledge, you know test an unknown transistor whose terminals are numbered #1,#2 and #3 and obtained the following result:

Red #1 #1 #2 #2 #3 #3
Black #2 #3 #1 #3 #1 #2
Result No Continuity, Continuity, No Continuity, Continuity, No Continuity, No Continuity

a) Is the Transistor Good or Bad?
b) Which terminals #1, #2 or #3 is the Base?
c) Is it PNP or NPN?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object

Answers: 1

Answer

You know the right answer?

For a Digital Muti-meter when set to the Diode Test, It will indicate continuity when the RED lead i...

Questions

Engineering, 13.02.2021 05:30

Problem 3 - An acrylic testing box is covered on the top with an unknown 15 mm insulation material with dimensions of 25 cm by 25 cm. A 25.0W bulb is...