Engineering, 06.06.2020 16:57 kaylag8242p2qj2e

A pH sensor is being used to measure real-time changes in pH of a microbial fuel-cell. An A/D converter with 14 bit resolution and a clock of 3.6 MHz is being used to sample and digitize the voltage readings that lie in a range of 0-10V.1. What is the resolution of the voltage signal? 2. What is the maximum error in Volts? 3. How many bits are needed to achieve a maximum error that is less than 0.2 mV? 4. What is the percent maximum error for V in the range (5 - 10](v)? 5. Find the maximum conversion time if the A/D was a successive approximation register (SAR).6. Suppose that the measurement is corrupted by 3-bit white noise, uniformly distributed. What is the variance of the noise in V and what would be the variance if we perform averaging of N values, where N = 2, 5, 107.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

Answer

Engineering, 06.07.2019 03:10

Consider a 1.2 meter high and 2 meter wide glass window whose thickness is 6 mm and thermal conductivity is 0.78 w/m °c. the room temperature is maintained at 24 °c, while the outdoor temperature is -5 °c. the convective heat transfer coefficients on the inner and outer surfaces of the window are 10 w/m2 °c and 25 w/m2 °c respectively. (a) draw the thermal resistance network, etermine the steady rate of heat transfer t e glass window (c) determine the temperature of the inner surface of the window

Answers: 3

Answer

Engineering, 06.07.2019 03:20

Major ingredients of traditional ceramics (a) silica (b) clay (c) feldspar (d) all

Answers: 1

Answer

You know the right answer?

A pH sensor is being used to measure real-time changes in pH of a microbial fuel-cell. An A/D conver...

Questions