Engineering, 10.06.2020 18:57 QuestionsAnsweredNow

2. For the three-layer system shown in the figure below with a= 120mm, q= 800Kpa, h1= 200mm, h2 = 100mm, E1 = 3Gpa, E2 = 150Mpa, and E3 = 75Mpa, determine all the stresses and strains at the two interfaces on the axis of symmetry. 30cm 30cm 45cm
400KPa
E= 3.5GPa , ν =0.5

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Inadequate stores control is not an obstacle to effective work order system. (clo4) a)-true b)-false

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?

Answers: 2

Answer

You know the right answer?

2. For the three-layer system shown in the figure below with a= 120mm, q= 800Kpa, h1= 200mm, h2 = 10...

Questions