Engineering, 20.08.2020 21:01 cbbentonam72

4. The input impedance to a transmission with characteristic impedance Zo connected to a load ZL is given below tan tan L o in o o L Z jZ l Z Z Z jZ l            where 2    , l is the length of the transmission line(usually given in wavelengths) and λ is the wavelength. a) Sketch Zin vs l (in wavelengths) if ZL=0, (i. e. a short circuit). What is the range of values for Zin? b) Repeat part a if ZL =[infinity] (i. e. an open circuit). c) How do the short circuited and open circuited transmission lines compare? d) How would the input impedance vary with length is ZL=75Ω and Zo=50Ω? e) In general, how does the input impedance of a terminated transmission line vary with distance from the load?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process

Answers: 1

Answer

You know the right answer?

4. The input impedance to a transmission with characteristic impedance Zo connected to a load ZL is...

Questions