Engineering, 24.09.2020 14:01 Campos101

A solar flux of 700 W/m2 is incident on a flat-plate solar collector used to heat water The area of the collector is 3 m2 and 90% of the solar radiation passes through the cover glass and it absorbed by the absorber plate. The remaining 10% is reflected away from the collector Water flows through the tube passages on the back side of the absorber plate and is heated from an inlet temperature T, to an outlet temperature T o The cover glass, operating at a temperature of 30 degree C. has an emissivity of 0.94 and experiences radiation exchange with the sky at - 10 degree C. The convection coefficient between the cover glass and the ambient air at 25 degree C is 10 W/m2 K a. Perform an overall energy balance on the collector to obtain an expression for the rate at which useful heat is collected per unit area of the collector. qw Determine the value of qc
b. Calculate the temperature rive of the water. if the flow rate is 0.01 kg/s. Assume the specific heat of the water to be 4179 J/kg K.
c. The collector efficiency eta is defined as the ratio of the useful heat collected to the rate at which solar energy is incident on the collector What is the value of eta?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

Answer

You know the right answer?

A solar flux of 700 W/m2 is incident on a flat-plate solar collector used to heat water The area of...

Questions