Engineering, 08.12.2020 16:50 skylex
Air with a stagnation temperature of 430o C and a stagnation pressure of 1.6 MPa enters a constant-area duct in which heat is transferred to the air. The Mach number at the inlet to the duct is 3 and the Mach number at the exit to the duct is 1. Determine the stagnation temperature and the stagnation pressure. Ignore the effects of friction.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
Air with a stagnation temperature of 430o C and a stagnation pressure of 1.6 MPa enters a constant-a...
Questions
Mathematics, 25.03.2020 20:30
History, 25.03.2020 20:30
Mathematics, 25.03.2020 20:30
Computers and Technology, 25.03.2020 20:30
Computers and Technology, 25.03.2020 20:30
Mathematics, 25.03.2020 20:30
