Engineering, 15.02.2021 20:30 laywah4
A tension member must be designed for a service dead load of 18 kips and a service live load of 2 kips.
Required:
a. If load and resistance factor design is used, determine the maximum factored load (required strength) and the controlling AISC load combination.
b. If allowable strength design is used, determine the maximum load (required strength) and the controlling AISC load combination.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10
Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?
Answers: 2
Engineering, 04.07.2019 18:20
Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives
Answers: 2
You know the right answer?
A tension member must be designed for a service dead load of 18 kips and a service live load of 2 ki...
Questions
Social Studies, 25.03.2021 03:50
Mathematics, 25.03.2021 03:50
Mathematics, 25.03.2021 03:50
Mathematics, 25.03.2021 03:50
Mathematics, 25.03.2021 03:50
History, 25.03.2021 03:50
Chemistry, 25.03.2021 03:50
