Engineering, 18.03.2021 17:50 eli761029

Problem 1: A package is released down on a ramp from the height hı, slides down and compresses the string by an amount d at the end of the ramp. Once the spring bounces back the package is pushed back on the ramp and travels up on the ramp until it momentarily stops at distance lz from the compressed position of the spring. If the coefficient of friction u = 0.3, angle a = 30°, spring deflection d = 0.1 m and length of the ramp package travels l; = 2.5 m, determine the height h2 the package will reach after it bounces back. Solve the problem using the principle of Conservation of Energy

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

When subject to a steady load (within elastic range) over a long period of time, what is the major difference in material behavoir between steel and plastic?

Answers: 2

Answer

Engineering, 06.07.2019 02:30

On solidification from a melt, the polymer polyethylene forms a semi-crystalline spherulite structure. (i) sketch an individual spherulite and label the amorphous and crystalline regions. (ii) draw a schematic to show the changes in specific volume with temperature during cooling from the melt, comparing it to the theoretical extremes of fully crystalline and fully amorphous (indicate tm and tg)

Answers: 2

Answer

Engineering, 06.07.2019 04:10

Aheat pump using refrigerant-134a heats a house by using underground water at 8°c as the heat source. the house is losing heat at a rate of 60,000 kj/h. the refrigerant enters the compressor at 280 kpa and 0°c, and it leaves at 1 mpa and 60°c. the refrigerant exits the condenser at 30°c. determine: (a) the power input to the heat pump, (b) the rate of heat absorption from the water, and (c) the increase in electric power input if an electric resistance heater is used instead of a heat pump

Answers: 2

Answer

You know the right answer?

Problem 1: A package is released down on a ramp from the height hı, slides down and compresses the s...

Questions