A workpiece in the form of a bar 100 mm in diameter is to be turned down to 70 mm diameter for 50 mm of its length. A roughing cut using maximum power and a depth of cut of 12 mm is to be followed by a finishing cut using a feed of 0.1 mm and a cutting speed of 1.5 m/s. It takes 20 s to load and unload the workpiece and 30 s to set the cutting conditions, set the tool at the beginning of the cut and engage the feed. The specific cutting energy for the material is 2.3 GJ/m3 and the lathe has a 3-kW motor and a 70 percent efficiency. Estimate:

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed