Engineering, 03.05.2021 05:10 wdgyvwyv8729
If the center of dilation is the origin in the diagram below, what would be the scale factor?
M м
L'
KO
ML
5. Which of the following explains a scale factor?
A. The distance between the two images,
D. The coordinate pair of the center of dilation
C. The number by which the distance from the center of dilation to an image is added to obtain
a similar image as measured from its center of dilation.
D. The number by which the distance from the center of dilation to an image is multiplied to
obtain a similar image as measured from its center of dilation
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 12:10
On a average work day more than work place firs are reorted
Answers: 1
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
Engineering, 04.07.2019 19:10
What are the major differences between injection molding and extrusion?
Answers: 2
Engineering, 04.07.2019 19:20
Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3
Answers: 2
You know the right answer?
If the center of dilation is the origin in the diagram below, what would be the scale factor?
M м<...
Questions
Computers and Technology, 22.11.2019 23:31
