A 30 MVA, 11.5kv, star -delta power transformer is to be protected by differential protection. The high voltage side face behind low voltage side phase by 30% formulate a complete differential protection for the transformer by selecting cut ratios, CTconnections. The continues current capacity of restraining coil of the differential relay should not exceed 5 amp ct ratio is 3000/5 on 11.5 kv side. Determine ct ratio 69kv side ​

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false

At steady state, air at 200 kpa, 325 k, and mass flow rate of 0.5 kg/s enters an insulated duct having differing inlet and exit cross-sectional areas. the inlet cross-sectional area is 6 cm2. at the duct exit, the pressure of the air is 100 kpa and the velocity is 250 m/s. neglecting potential energy effects and modeling air as an 1.008 kj/kg k, determine ideal gas with constant cp = (a) the velocity of the air at the inlet, in m/s. (b) the temperature of the air at the exit, in k. (c) the exit cross-sectional area, in cm2