subject
Engineering, 10.10.2021 14:00 patrickwilson

An oxygen tank with a volume of is kept in a room at 50°F. An engineer has used the ideal-gas equation of state to determine that if the tank is first evacuated and then charged with of pure oxygen, its rated maximum allowable working pressure (MAWP) will be attained. Operation at pressures above this value is considered unsafe. What is the maximum allowable working pressure (psig) of the tank?
You suspect that at the conditions of the fully charged tank, ideal-gas behavior may not be a good assumption. Use the SRK equation of state to obtain a better estimate of the maximum mass of oxygen that may be charged into the tank. Did the ideal-gas assumption lead to a conservative estimate (on the safe side) or a nonconservative estimate of the amount of oxygen that could be charged?
Suppose the tank is charged and ruptures before the amount of oxygen calculated in Part (b) enters it. (It should have been able to withstand pressures up to four times the MAWP.) Think of at least five possible explanations for the failure of the tank below its rated pressure limit.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
question
Engineering, 04.07.2019 18:10
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
You know the right answer?
An oxygen tank with a volume of is kept in a room at 50°F. An engineer has used the ideal-gas equati...
Questions
question
Mathematics, 02.08.2019 14:30
Questions on the website: 13722367