Engineering, 12.10.2021 02:00 marlesly87

Consider the process shown below in which a submersible pump at the bottom of a reservoir operates at steady-state pumpin water at a rate m = 9.0 lb/s to an elevated storage tank. Heat transfer between the pump and its surroundings is negligible. The velocity and temperature of the water do not change significantly between the pump inlet and the storage inlet. The water may be assumed to be incompressible fluid with density p=1.9 lb/ftÂ® and constant specific heat Cu = 1 Btu/lbÂ°R. The distance are zu = 20 ft and 24 = 18 ft. The pressures in the storage tank is given by P2 = 25.9 psi and the atmospheric pressure is given by Patm 14.5 psi. Assume g = 32.2 ft/s^2 Required:
What is the pressure at the inlet of the pump?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Air inially occupying a volume of 1 m2 at 100 kpa, 27 c undergoes three internally reversible processes in series. process 1-2 compression to 500 kpa during which pv constant process 2-3 adiabatic expanslon to 100 kpa process 3-1: constant-pressure expansion to 100 kpa (a) calculate the change of entropy for each of the three processes. (b) calculate the heat and work involved in each process. (c) is this cycle a power cycle or refrigeration cycle?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

You know the right answer?

Consider the process shown below in which a submersible pump at the bottom of a reservoir operates a...

Questions