Physics, 04.09.2019 21:20 ddmoorehouseov75lc

One of the most amusing things a person can experience is when a car in neutral appears to go uphill when its brakes are released. can this really happen? note that the car is an isolated system with no external force acting on it.

Answers: 3

Show answers

Another question on Physics

Physics, 21.06.2019 22:00

Atank holds 1000 gallons of water, which drains from the bottom of the tank in half an hour. the values in the table show the volume v of water remaining in the tank (in gallons) after t minutes.t(min) 5 10 15 20 25 30v(gal) 694 444 250 111 28 0(a) if p is the point (15, 250) on the graph of v, find the slopes of the secant lines pq when q is the point on the graph with t = 5, 10, 20, 25, and 30.(b) estimate the slope of the tangent line at p by averaging the slopes of two secant lines.(c) use a graph of the function to estimate the slope of the tangent line at p. (this slope represents the rate at which the water is flowing from the tank after 15 minutes.)show all steps.

Answers: 2

Answer

Physics, 22.06.2019 05:00

Which is the best predictor of the radioactive nature of an isotope? o the proton-to-electron ratio the neutron-to-proton ratio o the neutron-to-electron ratio the electron-to-proton ratio

Answers: 1

Answer

Physics, 22.06.2019 10:40

As you are trying to move a heavy box of mass m, you realize that it is too heavy for you to lift by yourself. there is no one around to , so you attach an ideal pulley to the box and a massless rope to the ceiling, which you wrap around the pulley. you pull up on the rope to lift the box. use g for the magnitude of the acceleration due to gravity and neglect friction forces. once you have pulled hard enough to start the box moving upward, what is the magnitude f of the upward force you must apply to the rope to start raising the box with constant velocity? express the magnitude of the force in terms of m, the mass of the box.

Answers: 1

Answer

Physics, 23.06.2019 00:40

Asteel tube (k=50 w/mk) of inner and outer diameter di = 20mm and do=26mm, respectively, is used to transfer heat from hot gases flowing over the tube (h-hot = 200w/m2k) to cold water flowing through the tube (h-cold = 8000 w/m2k). what is the cold-side overall heat transfer coefficient uc? to enhance heat transfer 16 straight fins of rectangular profile are installed longitudinally along the outer surface of the tube. the fins are equally spaced around the circumference of the tube, each having a thickness of 2mm and a length of 15mm. what is the corresponding overall heat transfer coefficient uc? *solve for uc in both cases*

Answers: 1

Answer

You know the right answer?

One of the most amusing things a person can experience is when a car in neutral appears to go uphill...

Questions