subject
Physics, 08.04.2020 15:27 cynthiagutierrez65

Let Tcomp(n, p) and Tcomm(n, p) denote the parallel computation and communica- tion times, respectively, on a parallel architecture for sorting n elements on p processors. Now consider routing a permutation on this architecture where each processor has a message of size m for another processor such that no two source or destination processors are the same. Design an algorithm to solve this permutation routing problem using only parallel sorting, and compute its run-time.

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 16:30
In raising a 6200-n piano with a pulley system, the movers note that, for every 2.2 m of rope pulled down, the piano rises 0.12 m . ideally, find the force required to lift the piano.
Answers: 2
question
Physics, 22.06.2019 00:00
(science)study the following ocean currents map. an ocean currents map is shown. on the map the locations for san diego, california and savannah, georgia are marked. there is a looping current from the north past san diego and a looping current from the south near savannah which statement is most likely correct about the average temperatures in san diego, california as compared to savannah, georgia? it is higher in savannah because of the cool ocean currents from the south. it is higher in savannah because of the warm ocean currents from the north. it is lower in san diego because of the warm ocean currents from the south. it is lower in san diego because of the cool ocean currents from the north.
Answers: 2
question
Physics, 22.06.2019 07:30
Boxing gloves are padded to lessen the force of a blow. (a) calculate the force exerted by a boxing glove on an opponent’s face, if the glove and face compress 7.50 cm during a blow in which the 7.00-kg arm and glove are brought to rest from an initial speed of 10.0 m/s. (b) calculate the force exerted by an identical blow in the gory old days when no gloves were used and the knuckles and face would compress only 2.00 cm. (c) discuss the magnitude of the force with glove on. does it seem high enough to cause damage even though it is lower than the force with no glove?
Answers: 1
question
Physics, 22.06.2019 14:10
Amachinist turns the power on to a grinding wheel, at rest, at time t = 0 s. the wheel accelerates uniformly for 10 s and reaches the operating angular velocity of 96 rad/s. the wheel is run at that angular velocity for 40 s and then power is shut off. the wheel slows down uniformly at 1.5 rad/s2 until the wheel stops. in this situation, the time interval of deceleration is closest to:
Answers: 3
You know the right answer?
Let Tcomp(n, p) and Tcomm(n, p) denote the parallel computation and communica- tion times, respectiv...
Questions
question
Mathematics, 26.08.2019 20:30
Questions on the website: 13722359