The cancellation of two waves occurs because of which of the following?

Follow these directions and answer the questions. 1. shine a pencil-thin beam of light on a mirror perpendicular to its surface. (if you don't have a laser light as suggested in the video, you can make a narrow beam from a flashlight by making a cone from black construction paper and taping it over the face of the flashlight.) how does the light reflect? how does the relationship of incident to reflected ray relate to the reflection of water waves moving perpendicular to a barrier? 2. shine a pencil-thin beam of light on a mirror standing on a sheet of paper on the table (or floor) so that you can mark the incident ray and reflected ray. (you can support the mirror from the back by taping it to a wooden block.) 3. mark a line on the paper representing the reflective surface. (the reflective surface of a mirror is usually the back edge.) 4. draw a dashed line perpendicular to the mirror surface at a point where the incident and reflected ray meet. this perpendicular is called a normal to the surface. 5. measure the angles between the rays and the normal. the angle of incidence is the angle formed by the incident ray and the normal to the surface. the angle formed by the reflected ray and normal is called the angle of reflection (r). what is the angle of incidence? what is the angle of reflection? 6. repeat for several different angles. (see report sheet for details.) what appears to be the relationship between the angle of incidence and angle of reflection? in science 1204, what was the relationship for these two angles made by the reflection of waves in a ripple tank? 7. roll a ball bearing so that it hits a fixed, hard surface (a metal plate) at several angles (including head-on). observe the way in which the ball bearing reflects. what generalization can you make about how a ball bearing reflects from a wall? have you proved that light can only behave like a wave?

The rigid beam is supported by the three suspender bars. bars ab and ef are made of aluminum and bar cd is made of steel. if each bar has a cross-sectional area of 450 mm2, determine the maximum value of p if the allowable stress is (σallow)st = 200 mpa for the steel and ( σallow)al = 150 mpa for the aluminum. est = 200 gpa and eal = 70 gpa.

What elements are found in the inner and out core of the earth? the correct layers of earth's interior from the top to the center? what is the unwanted material that is removed from a mine called? how much stronger is an earthquake that registers 5 on the richter as opposed to 2? what occurs at a convergence plate boundary? the majority of the the earth's rock what is the most common element found in the earth's crust? what element is found in pyrite that contributes to acid mine drainage? why must mining companies post bond prior to permitting? how are bacteria being used in treating effluent from mines? what is a problem of acid mine drainage in rivers and soils? what do tectonic plates move on? why is gold smelting so damaging? how are artesian wells formed? where is dammed water colder than the river it flows into? what is one of the problems of uncontained aqueducts? what is the largest use of industrial water? underground sand and gravel formations that can store water? what type of water test measure acidity? which type of water test for cloudiness from suspended solids? what water test measures the amount of calcium and magnesium? these are all problems of coal power plants all of the following are advantages of riparian lands along rivers what type of water would be the warmest and have the least amount of dissolved oxygen? the zone of aeration is