Engineering, 12.02.2020 03:28 blondieb1722
As part of a fabrication process, you encounter the following scenario. A vat contains 100 liters of water. In error someone pours 100 grams of a chemical into the vat instead of the correct amount, which is 50 grams. To correct this condition, a stopper is removed from the bottom of the vat allowing 1 liter of the mixture to flow out each minute. At the same time, 1 liter of fresh water per minute is pumped into the vat and the mixture is kept uniform by constant stirring.
Show that if x(t) represents the number of grams of chemical in the solution time t, the equation governing x is
dx/dt= -x/100
where x(0) =100. How long will it take for the mixture to contain the desired amount of chemical?
Answers: 3
Engineering, 04.07.2019 18:10
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
Engineering, 04.07.2019 18:20
Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process
Answers: 1
As part of a fabrication process, you encounter the following scenario. A vat contains 100 liters of...
Physics, 26.06.2020 15:01
Mathematics, 26.06.2020 15:01
Chemistry, 26.06.2020 15:01
Mathematics, 26.06.2020 15:01
Mathematics, 26.06.2020 15:01
Mathematics, 26.06.2020 15:01