Engineering, 20.03.2020 10:54 atsuedem974

During experiments on laser etching of microchips for IBM, a nuclear engineer places a discshaped sample 5 mm in diameter in a vacuum chamber with surface temperature of 300 K. A 500 mW laser is then used to irradiate the sample uniformly. The sample surface can be considered ‘gray’ with an emissivity of 0.9 and can be considered ‘thin’ so that the disk temperature is uniform. In addition, a non-participating gas at a temperature of 27⁰C is used to cool the sample with a convection coefficient of 50 W/(m2K). Find the steady-state temperature of the disk

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

You know the right answer?

During experiments on laser etching of microchips for IBM, a nuclear engineer places a discshaped sa...

Questions