Engineering, 05.11.2020 18:50 ellamai16
During a tensile experiment on a ductile material, the specimen will begin to neck prior to failure.
Why are true stress and true strain difficult to calculate after the onset of necking?
What tools could you use to measure true stress and true strain throughout the whole test?
Answers: 1
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Engineering, 04.07.2019 18:20
Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options
Answers: 2
Engineering, 06.07.2019 04:10
Aheat pump using refrigerant-134a heats a house by using underground water at 8°c as the heat source. the house is losing heat at a rate of 60,000 kj/h. the refrigerant enters the compressor at 280 kpa and 0°c, and it leaves at 1 mpa and 60°c. the refrigerant exits the condenser at 30°c. determine: (a) the power input to the heat pump, (b) the rate of heat absorption from the water, and (c) the increase in electric power input if an electric resistance heater is used instead of a heat pump
Answers: 2
During a tensile experiment on a ductile material, the specimen will begin to neck prior to failure....
Mathematics, 19.05.2021 14:00
Biology, 19.05.2021 14:00
Physics, 19.05.2021 14:00
Chemistry, 19.05.2021 14:00
Mathematics, 19.05.2021 14:00
English, 19.05.2021 14:00
Mathematics, 19.05.2021 14:00
Mathematics, 19.05.2021 14:00
Mathematics, 19.05.2021 14:00
Mathematics, 19.05.2021 14:00